Author Topic: Engine rebuild parts advice  (Read 148 times)

0 Members and 1 Guest are viewing this topic.

Offline hardy

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 176
Engine rebuild parts advice
« on: March 23, 2019, 11:59:56 PM »
Hi Guys,

After a 600 mile return ride to Albany from Bunbury and return in Western Australia, my gearbox has started to make more noise than it should. Long story cut short, I am sure I have dropped the gearbox bearing behind the clutch basket.

My question is, while I have the motor apart, what parts are recommended to replace? Obviously all rubber and gaskets will be replaced as standard procedure.

Any other advise I welcomed and I will continue to update the forum to “keep it alaive!”

Hardy
« Last Edit: March 24, 2019, 12:04:41 AM by hardy »

Offline BRT-GTR

  • Brian
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 900
Re: Engine rebuild parts advice
« Reply #1 on: April 09, 2019, 05:12:23 PM »
              I'd  replace the output shaft large bearing as well, this one has a hard life. Also check the needle bearing on the right end of the output shaft, I've found cracked rollers in those before now.  Any other issues with the box should become apparent when you strip it down.
              Also check the crank seal in the right disc cover and replace if the sealing lips are not soft and pliant.

     I have an engine with play in the shaft bearing behind the clutch. Did you find the engine vibrates badly above 4000rpm ?
             Brian         
« Last Edit: April 10, 2019, 07:57:45 AM by BRT-GTR »
Unspoiled by progress.
I'm so glad I grew up in the 60s & 70s. I did so much stupid stuff and there's no record of it.............Anywhere !!

 


Gallery


Views:13
Comments (0)
By: rwgibbon

Views:9
Comments (0)
By: rwgibbon

Views:19
Comments (0)
By: rwgibbon

Views:25
Comments (1)
By: rwgibbon

Classifieds

GTO
Date: 04/29/2020 11:27 am
Time Left:
Keys & Carb pieces wanted
Date: 04/23/2020 04:44 pm
Time Left:
Taka Rear Fender
Date: 04/03/2020 07:24 am
Time Left:
Wanted: 100TMX Oil Pump Inlet Spring and Check Ball
Date: 03/26/2020 11:40 pm
Time Left:

Recent Downloads added

350 GTR pdf version

Rating: (None)
Filesize: 7366.26KB
Date: March 14, 2020, 09:41:23 AM
Parts Manual for BS175-200 Lights
Rating: (None)
Filesize: 971.88KB
Date: March 06, 2020, 04:30:46 PM
!75 Wiring Diagram - Color Coded
Rating: *****
Filesize: 136.77KB
Date: February 27, 2019, 01:00:42 PM
11/01/1967 Factory Service Letter, RH shift/LH Brake conversion

Rating: (None)
Filesize: 92.56KB
Date: August 03, 2018, 02:49:08 AM

Powered by EzPortal