Hey Bert,
I started working on a new ignition for the 175/200. Very early so far, but I plan on making a plug that houses a bearing where the points plate normally goes. This will also act as the base for the stator. This is a combination of HPI ignition parts. The stator is approx 80mm in diameter so it will fit within the standard housing. It's a single 180 fire ignition but with a dual output coil. Once the bearing/base plate is made we will figure out the length the center shaft will need to be. The rotor weighs less than the internal rotor setup I have now. I'll keep you posted since it's been a bit of a slow go so far.
paul
[attachment deleted by admin]