Snapped a pic of my project. The frame has been degreased and sprayed (krylon), also polished up the rims and brakes. The transmission was frozen, so I opened it up for inspection- it looks like some moisture got in and froze up the shift drum and 1 bearing with surface rust. Cleaned it all up and changed the bearing. I also cracked a piston ring on disassembly of the cylinders (I was pretty rough trying to figure out what kind of bike it was), installed in a new one and buttoned it back up. Right now I am waiting for a new oil pump to come in, the original was kind of buggered and was missing a check valve. I hope to test the motor this weekend. If all is well I will move on to the bodywork- I would like to set this up as a racer with an airtech fairing (the original tank looks pretty bad currently). I was going to buy an airtech tank also, but now I am thinking I will fabricate a steel tank since I don't see any difficult compound curves to deal with. The ethanol in pump gas makes me worry about fiberglass tanks. Tony