Bridgestone Motorcycle Parts Discussion Board
General Category => General Discussion => Topic started by: fiction on October 25, 2010, 04:43:22 PM
-
hi,anyone have any tips or tricks how to get my circlips off to remove my pistons,all the other circlips have had a tang or holes for pliers,
these are just wire.
-
Fiction
When i work on circlips that have no tang or holes i use a old set of feeler gauge and i can get into the grove and lift the circlip
Up so you can get a pliers thin noses to remove the circlips.
Hope this helps.
Thanks.
Steve.
-
cheers for that steve, could not get the feeler gauge to work, but a bit of extra force with a screwdriver for repairing phones got em (think i was being a little too gentle because the pistons are new) . lance.