Bridgestone Motorcycle Parts Discussion Board
Bridgestone Tech Talk => 350 Talk => Topic started by: reed on August 23, 2010, 10:39:42 PM
-
Fork legs
If you are removing your fork legs to do seals etc.
When you are putting the fork legs back in the trees
in the UK we call it yokes. The springs are on the out
Side of the tubes so you can only push so far.
Get a bolt 10mm 1.25 and screw it in side the
tube and pull up.Then tighten the bolt at the bottom
Of the lower tree. remove bolt and install upper tree bolt.
Note the rear engine bolt is a 10mm 1.25 so you can in
A pinch use that!
Thanks.
Reed.