NICKEL SILICON CARBIDE COATING .

[reed]

Harry asked me would i look at his Bridgestone GTR engine.
To rebuild the engine and clean the crankcases etc.
I agreed to take the repair on but because of my time and
Work load in the workshop i would just pull the cylinders
And do the rest of the work in the winter time the cylinders
Walls had nickel-silicon carbide breaking up, so Harry sent
The cylinders to Millennium Technologies to be coated
I got the cylinders back that's a nice job that they do.
The cylinders are cleaned and bead blasted then bored.
Coated with a nickel-silicon carbide then diamond hone.
The finish  and the work is extremely good if you need
This type of work the phone number is Millennium
Technologies 920 893 5595.
Thanks.
Steve.

[Stephen Szikora]

What does it cost to have a pair of 350 cylinders done?

[old smokey]

Reed, does Millenium have all the specs to finish the 350 cylinders to stock specifications or do they have to be told in each case?
Any photos of their work?

[Sno Jet]

It is going to run you between $400 to $500 with shipping. This includes any welding that is necessary.

[coxy]

is millennium in Wisconsin ? this is something i will have to get done in the near future .i think its around $800 per bore here   cheaper in new Zealand but i think the way to go is to buy a set get them done in the states and shipped here its amazing the price difference between country's for the same job cheers 

[reed]

Picture of the Millennium work etc.
Thanks.
Steve.

[old smokey]

Yes Coxy, Millenium is located in Plymouth, WI, zip code 53073.
I can make it to them and back home again on less than a gallon of gas in the car