Bridgestone Motorcycle Parts Discussion Board
Bridgestone Tech Talk => 350 Talk => Topic started by: Kenneth Pagel on September 19, 2019, 05:30:28 PM
-
May be a dumb question, but I'll ask anyway: I assume the generator gear timing markhas be lined-up with the pinion gear timing mark before the RH inner case gets installed?
-
The simple answer is yes, they can't be lined up afterwards.
Also note there are two dots on the clutch driven gear which are matched to the marks you refer to. Make sure your crank pinion dot is lined up with the dot on crank end. Can be installed 180 deg out which will result in wrong plug firing or sparking at BDC.
-
Brian beat me to the answer. Also see the photo provided by Steve Reed in the post https://bridgestonemotorcycleparts.com/index.php?topic=2359.msg9648#msg9648
-
Karl, a picture is worth a thous......................................
Time difference tends to give me first shot at reply.
-
Thanks, everyone!