Author Topic: Oil Pump lines-GTR  (Read 721 times)

0 Members and 1 Guest are viewing this topic.

Offline Kenneth Pagel

  • Trade Count: (0)
  • Expert Registered Bridgestone Member
  • ****
  • Posts: 264
  • What, me worry?
Oil Pump lines-GTR
« on: May 15, 2021, 03:16:52 PM »
It seems that the oil feed line to the RH cylinder banjo fitting(as viewed when sitting on the bike) is quite long, and would form a considerable loopback on itself to attach to the banjo . Is this meant to be trimmed to have a smaller loop to the banjo? I recently purchased these NOS lines off flea bay, and both measure 13-1/2 inches. Thanks in advance!

Offline BRT-GTR

  • Brian
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 926
Re: Oil Pump lines-GTR
« Reply #1 on: May 16, 2021, 03:53:24 PM »
     Kenneth,   
            See Section 15 of the Engine assembly instructions in the manual, page 21 in mine.

      Left side oil line length 13.4''
      Right side line             14.6''

     Looks like you may have two left side oil lines but I am not sure how critical the stated lengths are. Trial fit the right side line, as long as the 'loop back' is not too tight and liable to kink, it should be fine. Right side oil line goes to the rear (inner) connection on the pump but this is not critical, either outlet connection can be used.
Unspoiled by progress.
I'm so glad I grew up in the 60s & 70s. I did so much stupid stuff and there's no record of it.............Anywhere !!

Offline Kenneth Pagel

  • Trade Count: (0)
  • Expert Registered Bridgestone Member
  • ****
  • Posts: 264
  • What, me worry?
Re: Oil Pump lines-GTR
« Reply #2 on: May 17, 2021, 12:21:31 PM »
Thanks, Brian!

Offline hardy

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 187
Re: Oil Pump lines-GTR
« Reply #3 on: July 22, 2021, 06:59:11 AM »
When I replaced mine, I just cut to length with one end installed.

 


Gallery


Views:13
Comments (0)
By: Steve Swan

Views:42
Comments (0)
By: rwgibbon

Views:36
Comments (0)
By: rwgibbon

Views:41
Comments (0)
By: rwgibbon

Classifieds

BS-7S/Surfrider piston rings and parts needed
Date: 12/03/2021 11:58 am
Time Left:
Need used rear spokes for BS 175. Three outer and One Inner. Any help greatly appreaciated
Date: 12/01/2021 01:08 pm
Time Left:
Need Hurricane 175 air tubes and front mud flap
Date: 12/01/2021 09:22 am
Time Left:
Need left side Battery Cover/ side cover HS175 200
Date: 11/04/2021 09:33 am
Time Left:

Recent Downloads added

BS200 Mk II RS & MK II SS Exclusive Parts
Rating: (None)
Filesize: 358.29KB
Date: March 07, 2021, 07:30:10 PM
1970 sales brochure
Rating: *****
Filesize: 6753.33KB
Date: July 16, 2020, 10:01:18 PM
2018 Article in Motorcycle Classics
Rating: (None)
Filesize: 3877.88KB
Date: June 29, 2020, 05:26:00 PM
350 GTR pdf version

Rating: *****
Filesize: 7366.26KB
Date: March 14, 2020, 09:41:23 AM

Powered by EzPortal