CORK-WASHERS.
When i pulled down the frame to be power coated i notice that the rear mudguard
Just bolted to the frame no rubber etc,So i have a snap on gasket making kit and
A roll of cork paper and i cut cork washers and put them between the frame and
The mudguard there are three bolts that hold the mudguard to the frame.Next
I looked at the front mudguard so again i use the cork washers between the mud
guard and the stays to cut out vibration,I also made a base for the rear tail light
unit,One thing to remember put a good ground cable from the tail light to a good
Ground to the frame.
Thanks.
Reed.