Forum > General Discussion
Dynetek DS2-1 Conversion to Bridgestone Points Housing
billdok:
Ray I believe "Old Swarthog" has answered your but question but in case you were still unsure, your wiring is correct. I believe "Old SwartHog" has also mentioned that you need need to have 3 ohms resistance including the coil resistance in the circuit and that is normally a resistor between +12volt and the coils.
Hope this helps.
OldSwartout:
The statement was "Dyna requires 3 Ohm or higher resistance coils. The BS350 coils are roughly 5 Ohms, so they should be fine." Just to be clear, the 5 ohm coils are OK without any added resistance, although some added resistance would cut down on coil heat and current draw if the spark wasn't adversely affected.
That's a nice clean conversion on your Bridgestone, billdok.
SR-175:
Hi Guys,
I wired the FTR project up as suggested and all went well. It fired up and runs fine. The 350 coils I fitted ran cool while being tested.
Added a few final photos of the project.
Thanks for the support ... ray
Navigation
[0] Message Index
[*] Previous page
Go to full version