Author Topic: Rotary Valve Friction on Reassembly of BS 200  (Read 208 times)

0 Members and 1 Guest are viewing this topic.

Offline jdbushnell

  • Trade Count: (0)
  • Registered Bridgestone Member
  • **
  • Posts: 15
Rotary Valve Friction on Reassembly of BS 200
« on: February 24, 2021, 10:11:21 AM »
Installed new rotary valves on my 200 after rebuild. When I replace the rotary valve cover and tighten it in place there is a noticeable increase in friction when trying to turn over the engine. Pre-rotary valve cover, engine turns freely by hand. Post-rotary valve cover can no longer turn with my fingers. Turns with using the kickstarter but there is obvious friction. Anyone with experience here? Does the new valve have to wear in a little? I have doubled checked the assembly and it appears correct (rubber O-ring seals properly in place, etc). Any thoughts?  Jeff

 


Gallery


Views:99
Comments (0)
By: Usedknobby

Views:108
Comments (0)
By: Usedknobby

Views:188
Comments (0)
By: Perry L Anderson

Views:161
Comments (0)
By: Perry L Anderson

Classifieds

GTO
Date: 06/09/2021 03:41 pm
Time Left:
GTO
Date: 05/25/2021 03:29 am
Time Left:
GTO
Date: 04/29/2021 04:31 pm
Time Left:
Looking for a TMX100 top end
Date: 03/25/2021 11:23 pm
Time Left:

Recent Downloads added

BS200 Mk II RS & MK II SS Exclusive Parts
Rating: (None)
Filesize: 358.29KB
Date: March 07, 2021, 07:30:10 PM
1970 sales brochure
Rating: *****
Filesize: 6753.33KB
Date: July 16, 2020, 10:01:18 PM
2018 Article in Motorcycle Classics
Rating: (None)
Filesize: 3877.88KB
Date: June 29, 2020, 05:26:00 PM
350 GTR pdf version

Rating: *****
Filesize: 7366.26KB
Date: March 14, 2020, 09:41:23 AM

Powered by EzPortal