Bridgestone 350 engines required

[bert Lilley]

Viny Hello from Canada, Vinny can i ask you for some information on your 175 Ignition systen, Can i put it in my 350 ??
I have been using a CB900 system but running into problems of late

Bert Lilley

[bsracer]

Hey Bert,

I started working on a new ignition for the 175/200. Very early so far, but I plan on making a plug that houses a bearing where the points plate normally goes. This will also act as the base for the stator. This is a combination of HPI ignition parts. The stator is approx 80mm in diameter so it will fit within the standard housing. It's a single 180 fire ignition but with a dual output coil. Once the bearing/base plate is made we will figure out the length the center shaft will need to be. The rotor weighs less than the internal rotor setup I have now. I'll keep you posted since it's been a bit of a slow go so far.

paul

[bert Lilley]

Hi vinny,well im talking to a guy in the states who is building a 175 street races yup hes going for it.
I remember you had parts you wished to sell for your175 racers. Do you have anything left from that lot ?.
How are your fleet of 200cc racers doing have you found any more power out of the rascals ?
I was thinging of putting together a 175 to competent my BS350 i have enging cases bored out cylinders ready for T6 alum. Liners etc. But stalled when i read the rules of only22mm cabs. BUT have found away around the ARHMA restrection and and waiting confirmation from a engineering source. So ill hang on for a little while .
Interested to see how your bike are doing
Best Bert

[cknight]

Sachse in Germany offers one for the 350 with programable timing curves. Easy to install, usual Sachse excellent quality.

[simonhk]

"Sachse in Germany offers one for the 350 with programable timing curves. Easy to install, usual Sachse excellent quality." Do you have a link to the unit?

[cknight]

Sachse does not list it on their site, as the spacers and trigger are made to order. Check out their Yamaha RD kit, and it's very similar.