Forum > How To

Simple Flywheel Removal Tool for 90 Motor

<< < (2/3) > >>

lhpegram:
additional picture

[attachment deleted by admin]

Mopar5426:
 After You Puts Some Presure On The Center Bolt Have You Tried A Sharp Rapp With A Hammer On The Center Bolt  That Should Help Jar It Loose

lhpegram:
sure did! to no avail.

thanks for the suggestion though

Mopar5426:
  That Leaves 3 Things Bigger Puller Bigger Hammer  & ALittle Heat Around The Hub    Good Luck  GENE

Bikenstein:
Try using a 1/4" to 1/2"plate. Make sure you pull from the center also to get even pressure. Looks like it's pulling off center because of the metal bending. Shorter bolts will also help as well as grinding a point on your center bolt. You should also be using hardened bolts and nuts on a puller. Grade 8 would be good. Otherwise you get to much stretch on the bolts and can't get a solid pull.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version