Author Topic: New gto good runner no gears  (Read 270 times)

0 Members and 1 Guest are viewing this topic.

Offline AlanJohn

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 69
New gto good runner no gears
« on: September 27, 2017, 08:00:56 AM »
Just started my latest gto and it runs really well then my luck ran out no gears they all select but the wheel runs free the clutch is really stiff and would be a misery to use is it possible it could have something to do with it any advise would be most appreciated thanks very much
Kind regards Alan John

I've just taken the clutch apart and with all the plates off and turning the basket by hand the back wheel turns and is in gear will a new set of plates cure the problem or can I do something with the old ones I don't know what a good or a bad plate should look like can anyone help please thanks

« Last Edit: September 27, 2017, 09:46:28 AM by AlanJohn »

Offline moonpup

  • Laidback Purist
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 1923
Re: New gto good runner no gears
« Reply #1 on: September 27, 2017, 11:37:40 AM »
Do you have 7 fiber discs, 6 metal discs and 1 thick aluminum spacer disc as seen in this pic?
Confucius say... "Better to have Bridgestone than Kidneystone"

Offline AlanJohn

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 69
Re: New gto good runner no gears
« Reply #2 on: September 27, 2017, 11:43:35 AM »
Yes l do
I think and hope the clutch cable is siezed the push rod is not going back flat against the back of the basket should it be able to??
Kind regards
Alan John

Offline moonpup

  • Laidback Purist
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 1923
Re: New gto good runner no gears
« Reply #3 on: September 27, 2017, 11:57:57 AM »
Ok, just thought I'd check and see if the previous owner had left something out or not, but I guess they didn't.

As far as the push rod going back flat, I don't have the answer off the top of my head and am unable at the moment to check what's happening on my bike.

Someone will probably jump in with the answer soon though and if not, I'll get back to you on that.
Confucius say... "Better to have Bridgestone than Kidneystone"

Offline moonpup

  • Laidback Purist
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 1923
Re: New gto good runner no gears
« Reply #4 on: September 27, 2017, 02:49:37 PM »
This is the position of the push rod with the pressure plate removed....
Confucius say... "Better to have Bridgestone than Kidneystone"

Offline BRT-GTR

  • Brian
  • Trade Count: (0)
  • Master Registered Bridgestone Member
  • *****
  • Posts: 622
Re: New gto good runner no gears
« Reply #5 on: September 27, 2017, 06:19:45 PM »
            From what you say, sounds like the pressure plate wasn't lined up on it's mark with the clutch centre. The p/plate will then sit on the center and can't compress the plates. IE, no drive to rear wheel. Shows you how in the manual.

   If clutch is stiff, clean the worm actuator on the left side, grease well before puting back and grease the pushrod parts at the same time, don't lose the 1/4 ball or 6x10mm spacer.
« Last Edit: September 27, 2017, 06:26:37 PM by BRT-GTR »
Growing old is compulsory, Growing up is optional.

Offline AlanJohn

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 69
Re: New gto good runner no gears
« Reply #6 on: September 28, 2017, 04:03:50 AM »
Thanks for your help
I think what I did was force the clutch lever in and it wouldn't release it now does and all the gears now work that's a relief although the clutch is slipping badly compared to a gearbox that's minor l'm sure it can't be difficult to adjust l'll have a go later
Kind regards
Alan John

Offline AlanJohn

  • Trade Count: (0)
  • Full Bridgestone Member
  • ***
  • Posts: 69
Re: New gto good runner no gears
« Reply #7 on: September 28, 2017, 05:51:06 AM »
Clutch now adjusted runs and rides really well
Thanks
Alan John

 


Gallery


Views:32
Comments (2)
By: OldSwartout

Views:47
Comments (2)
By: AlanJohn

Views:32
Comments (0)
By: AlanJohn

Views:34
Comments (0)
By: AlanJohn

Classifieds

unobtanium for sale
Price: $0.00
Date: 11/20/2017 12:51 am
Time Left: 89d 22h 9m
Steering Damper rod needed for GTR 350
Date: 11/03/2017 10:07 am
Time Left: 73d 6h 26m
Bridgestone Sport 100

Price: $175.00
Date: 10/31/2017 09:31 am
Time Left: 70d 5h 50m
1970 Bridgestone DT 175
Price: $1200.00
Date: 10/28/2017 06:08 pm
Time Left: 67d 14h 27m

Recent Downloads added

How to build a 149 mph 350GTR....
Rating: (None)
Filesize: 7154.56KB
Date: April 18, 2017, 08:25:38 AM
Bridgestone 100 Sport Brochure
Rating: *****
Filesize: 937.72KB
Date: July 08, 2015, 12:58:53 PM
BS 100 Sport Australian Brochure
Rating: *****
Filesize: 937.53KB
Date: June 29, 2015, 06:40:40 PM
Bridgestone 350 GTO - Moto L├ęgende May 2003
Rating: *****
Filesize: 9429.41KB
Date: April 22, 2015, 04:18:43 PM

Powered by EzPortal