Hi all,
I totally disassembled my 175's engine and have been following the Clymer Service Manual found in the downloads section of this site.
I've just about gotten everything back together but need a little clarification.
On page 23 of the .pdf, step #46 says to "Coat the left rotary valve cavity with oil". What is the rotary valve cavity? Just the area where the disc rests against the case halves? If so, any reason the manual says to do it for the left rotary valve but not the right?
The next question is in regards to steps #53 and #55:
53. Using a pressure type oil can inject oil
through the screw hole on the right side of the
oil injection pump until oil is seen coming out
of the oil level screw hole.
55. Using the pressure type oil can, fill the right
hand oil injection line before installing a line
onto the right banjo connector.
My question is, do these steps mean to use 2-cycle oil or regular engine oil?
Any help will be appreciated, thanks!
Paul