Author Topic: How do you get the choke cable out!  (Read 2546 times)

0 Members and 1 Guest are viewing this topic.

00davemag

  • Guest
  • Trade Count: (0)
How do you get the choke cable out!
« on: February 22, 2010, 08:19:37 PM »
I need help getting the choke cable out of the carb on a MKII. It would be nice to clean them up off of the bike :D

Offline reed

  • Bridgestone Technical Advisor
  • Trade Count: (2)
  • *******
  • Posts: 2384
Re: How do you get the choke cable out!
« Reply #1 on: February 22, 2010, 08:34:15 PM »
OOdavemag
If you send me your carb i will put it in the ultrasonic tank and heat the water up its works very well.
Reed

Online OldSwartout

  • Global Moderator
  • Trade Count: (0)
  • *******
  • Posts: 985
Re: How do you get the choke cable out!
« Reply #2 on: February 23, 2010, 09:52:34 AM »
After unscrewing the brass plunger cap and you find that the plunger is stuck in the carb, spray some penetrant down in there every day for a few days.  Usually the plunger will free up and you can pull it and the cable out.
Karl Swartout
Mooresville, IN
BS175 Roadracer
BS350 GTR

Offline reed

  • Bridgestone Technical Advisor
  • Trade Count: (2)
  • *******
  • Posts: 2384
Re: How do you get the choke cable out!
« Reply #3 on: February 23, 2010, 04:22:42 PM »
oodavemag
If you find the plunger still stuck the service is free
Reed

Offline Mopar5426

  • Trade Count: (0)
  • Expert Registered Bridgestone Member
  • ****
  • Posts: 315
Re: How do you get the choke cable out!
« Reply #4 on: February 24, 2010, 10:12:58 PM »
I Have Had The Sam Problem Getting The Choke Cable Out After Removing The Float Boal And Blowing It Clean I Toke A Map Gas Torch And Aplied A Little Heat At The Choke Area Along With PB Blaster An It Came Lose Good Luck

Online OldSwartout

  • Global Moderator
  • Trade Count: (0)
  • *******
  • Posts: 985
Re: How do you get the choke cable out!
« Reply #5 on: February 25, 2010, 09:26:22 AM »
The bottom of the plunger has a rubber seal, so don't get it too hot.  Of course, if  a lot of heat is the only way, the plungers can be replaced, they're standard Mikuni parts.
Karl Swartout
Mooresville, IN
BS175 Roadracer
BS350 GTR

00davemag

  • Guest
  • Trade Count: (0)
Re: How do you get the choke cable out!
« Reply #6 on: February 26, 2010, 03:49:01 AM »
Thanks guys for the info. Surprisingly it runs fine with them stuck. I will try the penetrate oil method first. 

 


Gallery


Views:11
Comments (0)
By: Geoff S

Views:22
Comments (0)
By: AlanJohn

Views:37
Comments (3)
By: mybridgestones

Views:59
Comments (2)
By: OldSwartout

Classifieds

Custom Made GTR/GTO Main Wiring Harnesses.

Price: $0.00
Date: 01/10/2018 10:40 am
Time Left: 80d 2h 23m
In Need of Center Crankshaft Bearing for 350 GTR

Date: 01/07/2018 04:30 pm
Time Left: 77d 8h 13m
Air Filter Joint Rubber

Price: $0.00
Date: 01/04/2018 03:57 pm
Time Left: 44d 7h 40m
Bridgestone Motorcycle t Shirts for sale

Price: $32.00
Date: 12/24/2017 03:50 pm
Time Left: 63d 7h 33m

Recent Downloads added

How to build a 149 mph 350GTR....
Rating: (None)
Filesize: 7154.56KB
Date: April 18, 2017, 08:25:38 AM
Bridgestone 100 Sport Brochure
Rating: *****
Filesize: 937.72KB
Date: July 08, 2015, 12:58:53 PM
BS 100 Sport Australian Brochure
Rating: *****
Filesize: 937.53KB
Date: June 29, 2015, 06:40:40 PM
Bridgestone 350 GTO - Moto L├ęgende May 2003
Rating: *****
Filesize: 9429.41KB
Date: April 22, 2015, 04:18:43 PM

Powered by EzPortal